Composite range · construction

Composite mesh for construction

Fibreglass mesh for reinforcing floors, screeds, paths, car parks, foundation slabs and stone facades. Six types from our own production in Podgorica — a replacement for steel mesh that doesn't rust.

Types
6 construction + fencing
Roll
1 × 20 m
Replaces
Steel mesh
Production
Podgorica
Green composite mesh with square openings, several layers stacked on top of each other
Composite mesh 15 × 15 × 8

What composite mesh is

Mesh you can carry by hand that doesn't rust in concrete.

Composite mesh is made of fibreglass bars joined into square openings. In concrete it works like steel mesh — it keeps the concrete from cracking — but it doesn't corrode and is several times lighter.

It is supplied in 20 m² rolls, so on site it is simply rolled out instead of lapping and tying sheet after sheet. For structural elements and heavier loads there is the 15 × 15 mesh with Ø6, Ø8 or Ø10 bars, in 2 × 6 m sheets.

  1. Floors, screeds and toppings

    10 × 10 × 3 mesh for floors in houses, screeds and toppings — one roll is rolled out across the whole room.

  2. Paths, pavements and car parks

    Surfaces that are walked and driven on and are constantly wet and salted — the concrete doesn't crack from rust.

  3. Foundation slabs and retaining walls

    15 × 15 structural mesh in three diameters for heavier loads, according to the design.

  4. Stone and clad facades

    5 × 5 × 3 and 10 × 10 × 4 mesh in facade layers — it takes up stresses and leaves no rust stains on the stone.

  5. Fences

    Fencing mesh 1.25 and 1.6 m high for gardens, plots and plantings — it needs no painting and doesn't rust.

  6. Easy installation

    One person can carry a roll; it is cut with bolt cutters and tied with wire or plastic cable ties.

Choosing the mesh

Which mesh for which use

The mesh designation is the mesh size in centimetres and the bar diameter in millimetres: 10 × 10 × 4 means a 10 × 10 cm opening made of Ø4 mm bars.

Recommended composite mesh by use, and the steel mesh it replaces
UseComposite meshReplaces steel
Screed, topping, floor in a house10 × 10 × 3Ø5 · 15 × 15
Facades and thin concrete layers5 × 5 × 3Ø5 · 15 × 15
Paths and pavements10 × 10 × 3 · 10 × 10 × 4Ø5 · Ø6
Car parks and industrial floors10 × 10 × 4 · 15 × 15 × 6Ø6 · Ø8
Foundation slabs, retaining walls15 × 15 × 6 · 8 · 10Ø8 · Ø10 · Ø12
Garden and plot fencesFencing mesh Ø3 · Ø4—

The replacement is indicative. For load-bearing elements the mesh is specified by the structural engineer — roll dimensions, formats and prices are in the mesh catalogue.

How it's installed

Roll out, lap, raise, concrete

The procedure is the same as with steel mesh — just without heavy sheets and a crane.

  1. 01

    Sub-base

    A compacted sub-base, with a membrane or waterproofing where needed.

  2. 02

    Rolling out

    The roll is rolled out and straightened, and the excess is cut off with bolt cutters.

  3. 03

    Lapping and tying

    Adjacent strips are lapped and tied with wire or cable ties.

  4. 04

    Spacers

    The mesh is raised on spacers — mesh lying on the ground reinforces nothing.

  5. 05

    Concreting

    The usual way, with no special concrete.

Our work

Mesh on site

Floors, paths, seafront slabs and facades — and deliveries from our warehouse. Click a photo to enlarge.

On site

Composite mesh laid for a concrete slab by the sea, with the open sea in the background
Seafront slabMesh laid for concreting, right by the shore.
Composite mesh laid over a membrane, ready for pouring a concrete floor
Ground-bearing floorMesh over a membrane, ready for pouring the floor.
Composite mesh laid in a strip between kerbs next to a new building, before the path is concreted
Path along a buildingMesh between kerbs, before concreting.
Green composite mesh rolled out and tied over a membrane on the sub-base
Rolled-out rollMesh tied over a membrane.
Composite mesh fixed over a stone wall, in a layer of render
Stone facadeMesh over a stone wall, in a layer of render.
Green composite mesh fence with posts next to a garden with artificial grass
Garden fenceGreen mesh on posts — no painting, no rust.

Delivery

Forklift loading a pallet of composite mesh rolls into a lorry
LoadingPallets of rolls go into the lorry by forklift.
Rolls of green composite mesh stacked in a lorry for delivery
Rolls in the lorryReady for delivery to site.
Several rows of green composite mesh rolls stacked side by side
From the warehouse20 m² rolls stacked for delivery.

Frequently asked questions

What we're asked most often

How big are the rolls?

The rolls are 1 m wide and 20 m long — 20 m² per roll. The 15 × 15 mesh is supplied in 2 × 6 m sheets, tied with galvanised wire.

Which mesh replaces steel mesh?

As a guide: 10 × 10 × 3 and 5 × 5 × 3 replace Ø5 steel mesh, 10 × 10 × 4 replaces Ø6, and 15 × 15 with Ø6, Ø8 and Ø10 bars replaces Ø8, Ø10 and Ø12 steel. For load-bearing elements, the structural engineer decides.

How is it cut and tied?

It is cut with bolt cutters or an angle grinder and tied with ordinary tie wire or plastic cable ties.

Does the mesh go in the concrete or under it?

In the concrete. The mesh is raised on spacers so that the concrete surrounds it on all sides — mesh lying on the sub-base takes up no stresses.

Where can I buy it?

Directly from us. Send an enquiry with the mesh type and quantity — we'll reply with a quote including the price and delivery time. All types and dimensions are in the mesh catalogue.